A retired A&P at DTW said torque specs are overrated, now I'm stuck thinking about both sides
Was standing behind this older guy at the parts counter at DTW last week and he said he never used a torque wrench on anything smaller than a 7/16 bolt, just went by feel after 30 years on the line. Half of me thinks that's how you end up with a stripped oil pan or a prop bolt that backs off, the other half thinks a guy with three decades on the hangar floor knows his hands better than a clicker that hasn't been calibrated since 2019. Our shop just got dinged on an audit for a torque wrench that was 6 ft-lbs off, so I'm leaning toward the book. Where do you all land on hand feel versus the wrench, and has an inspector ever called you out for skipping a spec?