Warning: a gust on the 14th floor in Amarillo taught me to check wind before every pick
Two summers back I was on a 6 story job in Amarillo running a 60 ton and the forecast said 8 mph. Around 2pm a gust came through and I watched my load swing about 4 feet without any warning on the anemometer. Turns out the gauge was mounted down low behind the building and never caught it. Since then I walk the load path with a handheld meter before the first pick of the day and write the readings on my clipboard. Cost me 10 minutes each morning but it caught a 19 mph gust last month that the cab gauge missed. Anyone else finding their cab mounted wind gear reads low on tight sites?
This is the same thing that happens with the thermostat in my house. It's right next to the return vent so it reads way colder than the rest of the room and the heat runs forever. The sensor is fine, it's just in a dumb spot. Seems like any gauge is only as good as where you put it, and the low spot behind a building is basically the vent in this case.