Serious question, how do you guys keep track of torque values when a job drags past one shift?
Last month I had a flap actuator swap on a King Air that carried over two shifts, and the handoff got messy. The guy before me wrote "re-torqued per manual" on the turnover sheet, but did not say which bolts or what value he actually used, so I redid half the work out of caution. It cost me 90 minutes and a lot of swearing. What fixed it for me was a cheap whiteboard marker and a strip of painter's tape on the wing root, where I wrote the values and the spec page right as I set each one. Photos on my phone at the end of shift, wipe it clean next morning. Simple but it stopped the guessing. Do you all have a better way to pass torque numbers to the next shift, or is tape and photos as good as it gets?