Question about replacing a control board on a Samsung dryer

Was working on a Samsung dryer in an apartment complex in Phoenix yesterday and the control board was completely fried from a power surge. I swapped it out but now the unit won't start at all - any of you run into this after a board replacement?

2 comments

2 Comments

leo_carr1313d ago

Honestly, @thomas105 is spot on with that ribbon cable thing. I read somewhere that it's a super common issue on these Samsung dryers especially after a board swap. Might be worth reseating both ends and giving it another try.

thomas10513d ago

Did you double check that the ribbon cable from the main board to the UI panel is seated all the way on both ends? I've seen those come loose during swaps and it'll kill all power to the unit.