Hot take: the 'test it till it fails' habit on line replaceable units is wasting our time
I was at the hangar in Burbank last week and a guy from the next bay over said something that stuck with me: "I don't trust a box till I've seen it quit at least once." Half the crew nodded like it was gospel. But I keep going back and forth on this. On one hand, I get it, you want to know how a unit acts when it's at the edge, and a bench check at room temp tells you almost nothing about a black box heading for a hot tarmac in Phoenix. On the other hand, I've watched guys burn a full shift cycling a unit past its rated limits, and all they got was a part that now acts flaky when it was fine out of the box. The manual gives you limits for a reason, and there's a line between stress testing and just beating on hardware. I've had units I ran to the edge pass fine and then fail in service a week later anyway, so what did that test even prove? Where do you all land on this, run it to the limit or trust the bench spec and move on?