Spent 11 hours chasing a fuel gauge fault that was a chafed wire 3 inches from the connector
Pulled the panel, rang out the sender, and even swapped the indicator on a King Air fuel gauge issue that kept showing an intermittent drop, and the actual fault was a chafed wire 3 inches from the connector that only showed up when the airframe flexed. What made it worse was the ohmmeter read fine every time we checked it on the ground, so we kept ruling out the harness until we did a wiggle test with the meter hooked up live. How do you guys catch intermittent wiring faults like this without pulling half the airplane apart, or do you just shotguns wires until it quits?
Wouldn't a meter with a min/max or peak hold do the same job without all the guessing? Hook it up live, go flex the airframe where you think the run is, then check if it caught a spike. Seems faster than shotgunning wires on a hunch, but maybe I'm missing something about how your runs are routed.