Vent: old hand at the Dayton shop told me to quit bumping my feed override and let the program run
He watched me baby a 4140 shaft for 40 minutes and finally said "you're fighting the machine, not running it," then had me run the next one dry at 100 percent and the finish came out cleaner than anything I'd babysat all week, so I'm wondering how many of you actually trust your speeds and feeds or still ride the dial like me.
you're fighting the machine, not running it" is a hell of a line. Did he say anything about how he dialed those feeds in the first place, or was it just years of trial and error on that same 4140? Curious if there's an actual method to trusting it or you just gotta eat a few scrapped parts first.